Hot-max-torches HTK-MD Manual do Utilizador

Operator’s Manual Medium Duty Torch Kit HTK-MD WARNING: Do not assemble, install or operate this equipment without reading ALL of this manual and the

KDAR Company 9 Operation 3. Press the oxygen cutting lever briefly to insure oxygen is flowing through the cutting hole. 4. Further adjustment may

KDAR Company 10 Maintenance and Additional Products General Maintenance 1. Prior to EVERY use, inspect hoses for damage. Note: Never try to repa

KDAR Company 1 Mulch Lane St. Louis, MO 63044 Phone: 314-692-8555 Fax: 314-692-8578 KDAR Company, and its affiliates, warrants that all torch kit

WARNING  Keep children away from this equipment  Protect your self and others from possible injury  Pacemaker wearers should consult with their

KDAR Company 2 CYLINDERS CAN EXPLODE IF DAMAGED  Gas cylinders contain gas under very high pressure. If damaged they can result in that cylinder ex

KDAR Company 3 Installation & Setup Features & Functions Features  Brass & Stainless Construction  Welds up to 1/2 Inch*  Cuts up

KDAR Com- 4 Installation & Setup Tanks The VTK-MD is designed to be used with CGA540 type tanks, these tanks can purchased or leased from your lo

KDAR Company 5 Installation & Setup It is important that all fittings have been tightened with a wrench by this point. Insure the tank valves, r

KDAR Company 6 Operation WARNING At this point the operator should be wear-ing appropriate protective clothing such as gloves and goggles. Lighting

KDAR Company 7 Operation Shutting Down 1. Using the acetylene control knob turn off the flow of acetylene to the welding tip. This will allow oxyge

KDAR Company 8 Operation 8. Check all connections for leaks. Leaks can not be seen, therefore, use soapy water on all con-nection points to insur